To mark the gauge centres, all I've done at this stage is to start a small hole with a 2mm bit, I'll then use this as a reference to scribe the gauge outlines to make sure I'm happy with the layout before committing myself further.
GD427 in action
Saturday, 7 May 2011
Beginnings of the Dash
I've started to mark out the dash ready to cut the holes for the gauges. I understand the later dash's are premarked by GD but mine is just blank so I enlisted some help from the Cobra Club and someone kindly sent me a template which I firstly transferred to graph paper and then used that as a guide to mark through onto masking tape behind.
To mark the gauge centres, all I've done at this stage is to start a small hole with a 2mm bit, I'll then use this as a reference to scribe the gauge outlines to make sure I'm happy with the layout before committing myself further.
To mark the gauge centres, all I've done at this stage is to start a small hole with a 2mm bit, I'll then use this as a reference to scribe the gauge outlines to make sure I'm happy with the layout before committing myself further.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment